1500 Tennessee Waltz ParkwayAshland City, TN 37015www.statewaterheaters.comPLACE THESE INSTRUCTIONS ADJACENT TO HEATER ANDNOTIFY OWNER TO KEEP FOR FUT
10grounding screw to tie into the metal panel to assure the unit isgrounded, see Figure 23.FIGURE 23TANK ASSEMBLY SYSTEMThe Tank Assembly is an 80 gal
11CABINET ASSEMBLYCABINET PANELSThere are five panels that comprise the cabinet assembly. Theends of the cabinet allow access to all controls and plu
12 WARNINGFLAMMABLE ITEMS, PRESSURIZED CONTAINERS OR ANYOTHER POTENTIAL FIRE HAZARDOUS ARTICLES MUST NEVERBE PLACED ON OR ADJACENT TO THE HEATER. OPEN
13RIG AND PLACE UNITInspect unit for transportation damage. File any claim withtransportation agency. Keep unit upright and do not drop. Spreaderba
14OUTDOOR STANDThis rooftop water heater is approved for an outdoor installationwith an optional stand. Contact State Order Entry to acquireoptional s
15VENTING WARNINGTHE INSTRUCTIONS IN THIS SECTION ON VENTING MUSTBE FOLLOWED TO AVOID CHOKED COMBUSTION ORRECIRCULATION OF FLUE GASES. SUCH CONDITION
16 WARNINGTHE HEATER IS NOT INTENDED FOR OPERATION AT HIGHERTHAN 14.0" WATER COLUMN (1/2 POUND OR 3.45 kPa PERSQUARE INCH) SUPPLY GAS PRESSURE. H
17Thermometers are installed in the system as a means of detectingthe temperature of the outlet water supply.RELIEF VALVEThis heater is equipped with
18FIGURE 36
19OPERATIONMENU NAVIGATIONThe EMC-5000 Interface has 5 buttons on the touch panel of the interface.The EMC-5000's menus are navigated through the
2ROOFTOP SRT80-120NEROUGH-IN-DIMENSIONSGAS VALVE PIPINGSRT80-120 1/2" NPTRecovery capacities are based on heater performance at 80% thermal effic
20Menu TreeMain Menu DescriptionTemperaturesOutlet Displays the temperature of the outlet tank probe.Tank Displays the temperature of the probe locate
21SEQUENCE OF OPERATION1. When the control is powered up the outdoor interface and theremote interface should display a blank line and copyright onthe
22The following are fault conditions related to the ignition module:Fault: I.M. LOCK OUTI.M Failed an internal hardware or software checkPossible Cau
23OPERATING INSTRUCTIONSIMPORTANTIT IS RECOMMENDED THAT A QUALIFIED SERVICE TECHNICIANPERFORM THE INITIAL FIRING OF THE HEATER. AT THIS TIMETHE USER S
24e. Repeat steps (c) and (d) until the specified input rate isachieved.f. Turn the manual gas valve to “OFF”. Replace the pressureregulator cover scr
25WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONSEXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSINGPROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.FOR
26GENERAL INFORMATIONPOWER BURNERThe SEQUENCE OF OPERATION is provided on page 21 and theINITIAL START-UP procedure of the unit on page 23.HIGH LIMITT
27Sediment and lime scale removal may be accomplished throughthe cleanout opening furnished on the heater. The heater mustbe drained, see DRAINING, be
28ONE TEMPERATURE - ONE HEATER HORIZONTAL STORAGE TANKFORCED CIRCULATION WITH OR WITHOUT BUILDING RECIRCULATION DANGERTEMPERATURE SETTING SHOULD NOT
29 DANGERTEMPERATURE SETTING SHOULD NOT EXCEED SAFE TEMPERATURE AT FIXTURES. SEE WATER TEMPERATURE CONTROL WARNING ON PAGE 5. IF HIGHERPREHEAT TEMPERA
3INSTALLATION INFORMATIONInstallation InformationModel: SRT80-120NE series Input: 120,000 btuhElectrical: 120/24VAC/60 Hz/5 A Side Clearances: 0&qu
30TWO TEMPERATURE - TWO HEATERS HIGH TEMPERATUREWITH OR WITHOUT BUILDING RECIRCULATIONTWO TEMPERATURE - THREE HEATERS (TWO PRE-HEATERS/ONE BOOSTER HEA
31* PIPE RELIEF VALVE TO OPEN DRAIN** 140°F (60°C)TO 150°F (66°C) SHOULD BE MAXIMUM WATERTEMPERATURE MAINTAINED IN THE PRE-HEATERS.120°F (49°C) SHOULD
32NOTE 1: TOGGLE SWITCH CONTROLS 180°F (82°C) WATERCIRCULATION. INSTALL ON OR CLOSE TO DISHWASHER.TOGGLE SWITCH MUST BE CLOSED (ON) DURING THE RIN
33CHECKLIST AND SERVICE INFORMATIONIMPORTANTThe installer may be able to observe and correct certain problemswhich might arise when the unit is put in
34NOTE: ANY BYPASS OR ALTERATION OF THE UNITS SAFETIESWILL RESULT IN VOIDING THE APPLIANCE WARRANTY.Before performing any troubleshooting familiarize
35MODEL SRT80 120NE LIMITED WARRANTYState Water Heaters, the warrantor, extends the following LIMITED WARRANTY to the owner of this water heater.1. TH
36500 TENNESSEE WALTZ PARKWAYASHLAND CITY, TN 37015Phone: 800-821-2017 Fax: 800-644-9306www.statewaterheaters.com
4This design complies with the current edition of ANSI Z21.10.3 asan automatic circulating tank type water heater and automaticstorage water heater.De
5Figure 1 shows the approximate time-to-burn relationship fornormal adult skin. Short repeated heating cycles caused by smallhot water uses can cause
6HIGH LIMIT SWITCH (E.C.O.)The top immersion well of the upper probe also contains the highlimit (energy cutoff) sensor. The high limit switch interr
7BLOWER ASSEMBLYThe blower assembly functions by pulling in air from outside theunit to supply to the burner assembly for proper combustion. Theblow
8AIR HOSEThe air hose is used to provide a flexible air path from the blowerto the burner assembly. It is held in place with two standard hoseclamps,
9LOW GAS PRESSURE SWITCHThe Low Gas Pressure Switch is a single pole, normally openpressure switch that will close its contacts when a rising pressure
Commentaires sur ces manuels